Veris-technologies 3150 Soil EC Mapping System - Operating Instructio Uživatelský manuál stáhnout pdf (Strana 15)

Pub. # OM17-EC

2-3

Figure 7. DataLogger (front)

Data Status:

When lit, this green

LED indicates data

is being recorded to

memory card. If not

lit, EC values are

negative or GPS

signal not received.

Power:

When lit, this red

LED indicates

Sensor DataLogger

is powered up.

Memory Card slot:

Formatted SD memory

card must be installed

when booting up, and

at all times data is

being collected. See

Proc. #6 for formatting

instructions.

Power port:

The Sensor DataLogger is

shipped with an accessory

power cord. If an alternative

connection is desired, make

sure that the unit is properly

connected to a power

connection that is not

controlled by the ignition

switch. If connecting directly

to the battery, we suggest a

3-amp in-line fuse is

installed between the battery

and the instrument.

EC:

Serial cable

from EC

Surveyor

attaches here.

pH:

Serial cable from pH

Controller (MSP

only) attaches here.

Reset

button:

Can be used

to reboot

DataLogger

Alarm Vol:

Used to adjust

volume of auditory

alarm

Fuse:

This allows the fuse

to be replaced, with

a 500mA Fastblow

fuse, if blown.

On/Off:

Turns power to

Sensor DataLogger

on and off.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 60 61

Komentáře k této Příručce

Žádné komentáře

Veris-technologies 3150 Soil EC Mapping System - Operating Instructio Uživatelský manuál Strana 15

Komentáře k této Příručce

Související produkty a manuály pro Zařízení Veris-technologies 3150 Soil EC Mapping System - Operating Instructio