Veris-technologies NIRS Spectrophotometer - QUICK REFERENCE CARD Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Zařízení Veris-technologies NIRS Spectrophotometer - QUICK REFERENCE CARD. Veris Technologies NIRS Spectrophotometer - QUICK REFERENCE CARD User Manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 4
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
3. Select field folder 4. Set port order (if changed)
Veris NIRS Spectrophotometer
QUICK REFERENCE CARD
(Refer to Operations Manual for complete instructions, including
software installation, safety, maintenance, and troubleshooting.)
1. Start up spectrometers 20
minutes before using. Leave
vehicle running to keep battery
charged. (amperage draw is 10
amps if cooler is running; 1 amp
otherwise)
6. Clean window, and place external references (ER)
against window. Soil may need to be removed from shoe
holes. Press corresponding button when Program State
reads REST. Continue until all ER lights are green or yellow.
2. Start software.
Refer to Operating
Instructions for
software installation
procedure.
5. Press System Check button
7. Press End (F12) to transform.
8. Green light
indicates when
transform is
complete.
READY
TO MOVE TO
NEXT STEP—
DATA
ACQUISITION.
Press Close
Window/F12 to
move back to
main interface
screen.
Zobrazit stránku 0
1 2 3 4

Shrnutí obsahu

Strany 1 - QUICK REFERENCE CARD

3. Select field folder 4. Set port order (if changed)Veris NIRS SpectrophotometerQUICK REFERENCE CARD(Refer to Operations Manual for complete i

Strany 2

9. Before mapping complete all steps above. Make sure Reference Check (Ref Check) light is green, all Auxiliary Case lights are green, and GPS data a

Strany 3

14. When all data have been acquired press F12 or End to return to the main interface screen, shown below. Press #3 Extraction to the bytestream files

Strany 4

17. Press #5 to initiate the clustering program--it will ask if the settings are correct. The settings are the number of clusters or sample locations

Komentáře k této Příručce

Žádné komentáře